-
Tool car workshop for decoding units
Decoder 7
Decoder 7 is a digital programmer to set up and deletion of code-Marelli IAW 8F immobilizer control units - 16F - 18F. The scodifica the unit is via an innovative procedure that avoids unsolder and remove the original EPROM. The kit contains a dedicated software for reprogramming and the cancellation of the procedure code with the serial.
Technical Sheet -
Ecu Decoding tool for garage
Decode module
This decode module are an add module for car, installed parallel to the original system of the car, to simulate the electronic signal on the original car. This module allows to start the engine with the "code immobilizer" disabled. Celeste Electronic Car Tuning has just put different types of module "decoder" compatible with major car brands.
Technical Sheet -
Tool car workshop for processing units and test
Eprom programmer
VP 590 is a universal programmer N / CMOS E (E) PROM, Series E (s) and Flash Memory prom PLD: CPLD, EPLD BOX. The programmer for additional parking ECU Flash uses digital technology to ensure reliable programming 100% of the devices. It does, moreover, the automatic detection of devices piedatura from 20 to 40 pins. The programmer comes with 590 Vp adapters for EPROM and Flash needed to intervene on the units related to the automotive group.
Technical Sheet -
Tool car workshop for decoding units
Drc decoder
The software decoder DRC is an innovative digital instrumentation that allows you to regenerate the resin type Magneti Marelli electronic control units, Sagem, Siemens. The electronic device allows for the correction of the file unit number and "riverginare" a unit used without resorting to software and PC connections, using the Rolling Code System Coupled with the devices and decoder Decode D45M 7 makes service scodifica more complete because it increases the number of units that can be decoded. The kit contains the programming cable, power supply and bench manual for procedures and techniques used.
Technical Sheet -
Ecu Decoding tool for garage
Idec 59f
The IDEC 59 F is a digital electronic device that enables "revergination" the Marelli IAW ecus of the car all done automatically without opening the unit. In the kit is comprised a dynamic programming software and intuitive that, with extreme simplicity, involves the possibility of read / write complete the ecu via the serial port, in addition to the wiring for the control units listed above.
Technical Sheet -
Software to delete the code immobilizer
Software decoding units
Celeste ecudec is the ideal software for partial or total cancellation of the immobilizer code present in the engine management unit.
Technical Sheet
The tools allow for decoding units to act in different ways to regenerate or riverginare control units of different car models (Marelli IAW 8F, 16F, 18F, Magneti Marelli, Sagem, Siemens) automatically and without opening the unit. Software you can clear the immobilizer code (code-immobilizer) or, through the parallel plates of scodificainstallati the original system of the car, simulating the electronic signal present in the original key of the car.